An MSK PLUS set with a Ø150 damper is a modern fireplace controller with a screen, which can be used for all air and water jacket inserts. It controls the temperature of the air heated by the insert or the temperature of water in the water jacket. It enables controlling the temperature at 3 various locations in the system and independent control of 4 devices, such as pumps, fans or solenoid valves. Its task is the using an electronic damper to supply cold outside air (for combustion) to the combustion chamber, so that it is maximally effective, while maintaining the set value of controlled temperature. Thanks to its application, we are able to save up to 30% of timber and already after 2 months of operation, pays itself back.
CONTROLLER FUNCTIONS:
- independent control of four devices, e.g. c.h. pumps, fans or solenoids
- precise dosage of combustion air
- overheating protection
- cutting off air supply in the event of a power outage
- acoustic warnings
- circulating water anti-freeze function
- post-season circulating pumps run-up function, when they are not use in the off-season.
THE SET INCLUDES:
- microprocessor controller
- 1 temperature sensor with a 1m long silicone cable
- 2 temperature sensors on 1m long PVC cables
- damper with a servomechanism
- connector cable to the damper
- spare T4/250V fuse
- jumper
- assembly box.
The damper is equipped with a special gasket, which makes isolating outside air (combustion) complete. After the glow goes out in the insert, the controller automatically closes outside cold air inflow, thanks to which the hearth and apartment do not cool down immediately.
NOTE! In cast iron fireplaces, the sensor cannot be places on the insert, since it can melt because of the temperature.
Controlling an oil or gas furnace in a system with a fireplace is automatic. If we light a fire in the fireplace, the oil or gas furnace controls will automatically record increased temperature in the house, therefore, will not activate an oil or gas furnace until the fire in the fireplace is put out. At night, when the timber in the fireplace starts to deplete and the temperature will begin to decrease, an oil or gas furnace will automatically activate. Therefore, there is no need to connect a fireplace controller with the oil or gas furnace controller.
![Daiei Vamzdžio temperatūra x vandens karšto karščio kibiro šildytuvas [Nagecom Den-Heat] šildytuvas, valdymas, DB-1000S (430mm 65mm), termostatas, panardinamas šildytuvas, katilas,](https://img.joomcdn.net/e00e42817533b60f482f03427c26d76f040bd901_100_100.jpeg)
