Product Name: Forward Inverse Switch
Input Voltage: 12V - 72V
Load Current: Max. 30A
Color: Black
Type: Normally Open
Features:
- Widely Application: Can used for various types linear actuator controller, suitable for positive and negative control of motors in garage doors, electric gates, traction winches, conveyors, wireless security alarms, roller shutters, power awnings, and any applications with forward and inverse motion capabilities.- This dc motor forward and inverse switch, can remotely operate the the DC motor through the remote control. Working voltage 12V - 72V, maximum current 30A. Stable and reliable performance with high reception sensitivity.
- Remote Control: Equipped with 2 remote controllers, has strong signal that can pass through walls, floors and doors, can control the motor forward or inverse by remote control within 168ft under accessibility, will not interfere with other wireless devices operating nearby.
- Easy to Use. The product manual describes in detail how to wire and how to use it. This switch also can programmed to control multiple winches simultaneously. The indicator light on the controller is red when it is in the programming state, and green when the controller is in the operating state. The indicator light on the remote control is red when the button on the remote control is pressed.
- Momentary and self-locking two modes: Two modes can be freely switched according to your needs. It is factory set to self-locking mode, if you need to switch to momentary mode, please refer to the manual. It can be used alone to control all types of linear actuators or with a solenoid relay contactor to control winches from other manufacturers.
How to use self-locking mode:
Press remote control up button once, the motor rotates positively; press remote stop button, the motor stops rotating.
Press remote control down button once, the motor will rotate in the inverse direction; press remote control stop button, the motor will stop rotating.
How to use momentary mode:
Press remote control up button, the motor rotates positively, release up button, the motor stops rotating;
Press remote control up button again, the motor rotates positively again, release up button, the motor stops rotating;
Press and hold the up button, the motor rotates continuously.
The same principle applies to the down button.
How to change to momentary mode:
Step 1: Press and hold the programming button on top of the switch, the light will come on, the light will flash 1 time after about 2 seconds,then release the button
Step 2: Press up button of the remote control once, then press down button of the remote control again.
Step 3: The light on the top of the switch will flash 3 times, programming is complete.
How to change to self-locking mode:
Step 1: Press and hold the programming button on top of the switch, the light will come on, the light will flash 1 time after about 2 seconds,do not release continue to press and hold the button, after about 2 seconds the light will flash 2 times then release the button.
Step 2: Press up button of the remote control once, then press down button of the remote control again.
Step 3: The light on the top of the switch will flash 3 times, programming is complete.
Package Including:
1 x Relay Receiver
2 x Remote Controls
1 x Product Manual
The merchant warrants that their products comply with all applicable laws, and are offered only if they comply with Joom's policies and EU Product Safety and Compliance laws.
Nėra pristatymo grąžinimas
