Car Top Roof Seal Strips Seal Protector Sticker Edge Windshield Roof Sealing Strip

Type: Car top roof seal strip Material: rubber Applicable: Sealing protection sticker edge windshield roof Name: sealing strip This replaces the top rubber above the chrome trim and only wraps the rear above the trunk and quarter panels. This is an area prone to aging, sunburn, etc. All you need is a sharp craft knife or similar tool to remove the old rubber piece on top of the old weather seal, making sure you've removed all of the old rubber layer to the plastic. The rubber is self-adhesive with 3M tape and the total length is approximately 2 meters. The third brake light needs a small amount of trimming in and around the length. Guided steps: Step 1: Clean the surface to allow the adhesive to fully bond and achieve maximum adhesion. Step 2: Place the new rubber strip on top of the flat edge where the rubber was removed and overlap it onto the roofing material, adding glue to aid in the bonding process. Make sure the positioning is correct as the glue will set in 15 seconds! The new rubber is slightly increased in size and overlaps the chrome, but looks 100% better, helps restore the weather seal and protects the seams from UV rays produced by the sun. As with most convertibles, avoid jet cleaning the roof and new seals. If necessary, clean these areas with a sponge and rinse with a bucket. It is best to use superglue (not included) applied along hidden areas to avoid any lifting during exercise etc. or apply silicone beads as needed. It is possible and recommended to remove the strips to complete the cut from the car and avoid cutting the roof fabric. Tamper-resistant Torx screws are located beneath the chrome strip and are accessed by releasing the side latches. (Boot loading mode) This allows the lower roof to tilt. Use suitable props to support opening. Package Included: 1x replacement self-adhesive rubber seal